Skip to main content
日本語 简体中文 繁體中文

[Access Control] Create / Edit IP Sets

Overview

This article explains how to create and edit IP Sets for administrators responsible for the initial setup and ongoing management of Access Control.

Notes

  1. The content of this article is based on product specifications as of June 2026 and is subject to change without notice.
  2. Global administrator privileges for Access Control are required to view the actual screens or make configuration changes.
  3. For instructions on how to access the Administration, please refer to the following article.
    How to Access the Access Control Administration

Procedure

  1. In the Access Control Administration, go to [Access Control] – [IP Sets] from the left menu.

    Screen showing selection of IP Sets from the left menu in Access Control Administration

  2. Click [Add IP Set] in the upper right corner, or select one of the existing IP Sets.

    Screen showing the Add IP Set button or selection of an existing IP Set

  3. Configure [ID], [Display Name], and [IP Address], then click [Save].
    * Once created, the ID cannot be changed. If you create it incorrectly, please delete it and create a new one.
    * For details on each setting, see Fields (IP Sets).

    To register multiple IP addresses at once, click [Import IP addresses].
    An input screen will appear; add each address on a new line or replace the existing ones as needed.

    Screen for entering and saving the ID, Display Name, and IP Address for an IP Set

Next Steps

Set the created/edited IP Sets in the Access Policy Templates.
When specifying an IP Set in the predicate of an Access Policy Template, enclose the group name with single-byte "@" symbols.
Example: If the ID of the IP Set is "office_osaka", specify it in the predicate as shown below.

@office_osaka@

* If you have already set an IP Set in the Access Policy Template, no further action is required.
* For detailed configuration steps, please refer to the following article.
Creating and Editing Access Policy Templates in Access Control

Fields (IP Sets)

Field Content Notes
ID The value used to configure IP Sets in [Access Policy Groups] and [Issue entrance pass on login] ID must be between 3 and 255 characters in length.
Allowed characters: alphanumeric, hyphen, dot, and underscore.
Duplicate IDs cannot be registered.
Display Name Name of the IP Set Display Name must be 256 characters or fewer.
IP Address IP addresses to register You can register up to 100 IP addresses in a single group.
Duplicate IP addresses cannot be registered in the same group.

Translation Disclaimer

This article has been automatically translated from the original Japanese version for your convenience.While we strive to ensure accuracy, we cannot guarantee its reliability or completeness.
In the event of any discrepancies or questions regarding the content, the official Japanese version shall prevail.