[Access Control] CUA Configuration for SAML Response

Overview

This article explains how to add CUAs created in the Access Control Administration to a SAML Response.
It is intended for Admins who perform initial Configuration and operational management.

Notes

1. The content of this article is based on product specifications as of November 2026 and is subject to change without notice.
2. Global Admin permissions for Access Control are required to review the actual screens and change Configuration.
3. For information on how to access the Administration, refer to the following article.
   [Access Control] How to Log in to the Administration

Procedure

1. In the Access Control Administration, go to ［System］－［Edit Connected Service］ in the left-side menu.

   

2. Click any Set connected service.
   Alternatively, refer to the following manual site to create a new Edit Connected Service.
   [Access Control] How to Configure HENNGE One Settings for SAML Connection (for Custom Registration)
3. At the bottom of the displayed screen, click ［Attribute Editor］－［＋Add new attribute row］.
4. For ［Attribute］, set the Attribute name specified by the Target connected service.
   Click ［Value］, and then select the configured CUA from the displayed drop-down list.

   

Translation Disclaimer

This article has been automatically translated from the original Japanese version for your convenience.
While we strive to ensure accuracy, we cannot guarantee its reliability or completeness.

In the event of any discrepancies or questions regarding the content, the official Japanese version shall prevail.