[HENNGE Connect] List of Setup Procedures

Description

This guide provides instructions for customers implementing HENNGE Connect on how to access on-premises web services via Access Control.

Notes

1. Please check the required items according to your service and usage.
2. The content of this article is based on the product specifications as of April 2026 and is subject to change without notice.

Table of Contents

• Preparation
• HENNGE Connect Agent Installation
• Operation Test

Preparation

1. Check the system requirements and make sure that the requirements are met.
2. Configure the service provider settings for HENNGE Connect.
3. For using HENNGE Connect, define the requirements based on the determination of the public URL, HENNGE Connect Agent settings, and information required for file creation.

HENNGE Connect Agent Installation

1. Based on the defined requirements, HENNGE will build and enable the HENNGE Connect environment and provide the necessary information to the customer.
2. Install the HENNGE Connect Agent on the on-premises server.
3. Set up the configuration file (config.yml) for the first time.
4. Run the HENNGE Connect Agent.

Operation Test

1. Access the Access Control User Portal screen.
   For instructions on how to log in to the User Portal, please refer to the following article.
   [Access Control] User Guide
2. After navigating to the User Portal site, confirm that you can access the on-premises web service via Access Control.
   * After authentication with Access Control is complete, authentication on the on-premises web service will be required.
3. Once you have confirmed access, please contact your HENNGE representative.