[Mesh Network] List of Setup Procedures

Overview

• This article explains the steps for customers implementing Mesh Network to start using Mesh Network.

Notes

1. Please check the required items according to your connected service and intended use.
2. The content of this article is based on the product as of August 2026 and is subject to change without notice.

Table of Contents

1. Preparation
2. Initial Setup and Configuration

Preparation

1. Clarify the purpose and requirements for implementation
   Based on the purpose of implementing Mesh Network, organize the devices that require client installation and check the ports used on the destination servers.
2. Check target devices for implementation
   Confirm the devices, servers, etc. where you want to use Mesh Network.
   Also check whether client installation is possible.
   HENNGE One System Requirements
3. Check the existing network environment
   Mesh Network uses CGNAT (Carrier-Grade NAT).
   When configuring Mesh Network, also check any existing network devices that may be involved.
   • For devices such as firewalls, confirm that communication is allowed on the physical network for Mesh Network use
   • For devices such as firewalls and proxies, check for any communication considerations when using Mesh Network
   • For private IP address ranges, especially check for overlapping ranges between sites
4. Log in to the Mesh Network Administration
   Confirm that you can log in to the Mesh Network Administration using the initial administrator address specified in the HENNGE One service application form.

Initial Setup and Configuration

1. Email Routing Design
   Based on the target devices confirmed during preparation, design the email routing, including the placement of Subnet Linker and configuration of Split DNS as needed.
2. Existing network design
   Modify the settings of existing network devices as necessary.
   • Firewall
   • Proxy
   • Private IP address range
3. Mesh Network Configuration
   Based on your design, perform the necessary tasks such as installing the client on required devices.
   1. [Mesh Network] How to Install the Client (Windows PC)
   2. [Mesh Network] How to Install the Client (Windows Server)
   3. [Mesh Network] How to Install the Client (Linux Server)
   4. Create a fleet
   5. Create a group
   6. [Mesh Network] Create a Subnet Linker
   7. [Mesh Network] Create a New ACL (Access Control List)
   8. Create Split DNS